Cisco Catalyst 3750-X Command Reference

2-396
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
mls qos aggregate-policer
mls qos aggregate-policer
Use the mls qos aggregate-policer global configuration command on the switch stack or on a standalone
switch to define policer parameters, which can be shared by multiple classes within the same policy map.
A policer defines a maximum permissible rate of transmission, a maximum burst size for transmissions,
and an action to take if either maximum is exceeded. Use the no form of this command to delete an
aggregate policer.
mls qos aggregate-policer aggregate-policer-name rate-bps burst-byte exceed-action {drop |
policed-dscp-transmit}
no mls qos aggregate-policer aggregate-policer-name
Syntax Description
Defaults No aggregate policers are defined.
Command Modes Global configuration
Command History
Usage Guidelines Define an aggregate policer if the policer is shared with multiple classes.
Policers for a port cannot be shared with other policers for another port; traffic from two different ports
cannot be aggregated for policing purposes.
The port ASIC device, which controls more than one physical port, supports 256 policers on the switch
(255 user-configurable policers plus 1 policer reserved for internal use). The maximum number of
configurable policers supported per port is 63. Policers are allocated on demand by the software and are
constrained by the hardware and ASIC boundaries. You cannot reserve policers per port (there is no
guarantee that a port will be assigned to any policer).
You apply an aggregate policer to multiple classes in the same policy map; you cannot use an aggregate
policer across different policy maps.
aggregate-policer-name Name of the aggregate policer referenced by the police aggregate
policy-map class configuration command.
rate-bps Specify the average traffic rate in bits per second (b/s). The range
is 8000 to 1000000000.
burst-byte Specify the normal burst size in bytes. The range is 8000 to 1000000.
exceed-action drop When the specified rate is exceeded, specify that the switch drop the
packet.
exceed-action
policed-dscp-transmit
When the specified rate is exceeded, specify that the switch change the
Differentiated Services Code Point (DSCP) of the packet to that
specified in the policed-DSCP map and then send the packet.
Release Modification
12.2(53)SE2 This command was introduced.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing