Cisco Catalyst 3750-X Command Reference

2-964
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
traceroute mac
traceroute mac
Use the traceroute mac privileged EXEC command on the switch stack or on a standalone switch to
display the Layer 2 path taken by the packets from the specified source MAC address to the specified
destination MAC address.
traceroute mac [interface interface-id] {source-mac-address} [interface interface-id]
{destination-mac-address} [vlan vlan-id] [detail]
Syntax Description
Defaults There is no default.
Command Modes Privileged EXEC
Command History
Usage Guidelines For Layer 2 traceroute to function properly, Cisco Discovery Protocol (CDP) must be enabled on all the
switches in the network. Do not disable CDP.
When the switch detects a device in the Layer 2 path that does not support Layer 2 traceroute, the switch
continues to send Layer 2 trace queries and lets them time out.
The maximum number of hops identified in the path is ten.
Layer 2 traceroute supports only unicast traffic. If you specify a multicast source or destination MAC
address, the physical path is not identified, and an error message appears.
The traceroute mac command output shows the Layer 2 path when the specified source and destination
addresses belong to the same VLAN. If you specify source and destination addresses that belong to
different VLANs, the Layer 2 path is not identified, and an error message appears.
If the source or destination MAC address belongs to multiple VLANs, you must specify the VLAN to
which both the source and destination MAC addresses belong. If the VLAN is not specified, the path is
not identified, and an error message appears.
interface interface-id (Optional) Specify an interface on the source or destination switch.
source-mac-address Specify the MAC address of the source switch in hexadecimal format.
destination-mac-address Specify the MAC address of the destination switch in hexadecimal format.
vlan vlan-id (Optional) Specify the VLAN on which to trace the Layer 2 path that the
packets take from the source switch to the destination switch. Valid VLAN
IDs are 1 to 4094.
detail (Optional) Specify that detailed information appears.
Release Modification
12.2(53)SE2 This command was introduced.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing