B-17
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
debug ilpower
debug ilpower
Use the debug ilpower privileged EXEC command to enable debugging of the power controller and
Power over Ethernet (PoE) system. Use the no form of this command to disable debugging.
debug ilpower {cdp | controller | event | ha | port | powerman | registries}
no debug ilpower {cdp | controller | event | ha | port | powerman | registries}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines This command is supported only on PoE-capable switches.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
cdp Display PoE Cisco Discovery Protocol (CDP) debug messages.
controller Display PoE controller debug messages.
event Display PoE event debug messages.
ha Display PoE high-availability messages.
port Display PoE port manager debug messages.
powerman Display PoE power management debug messages.
registries Display PoE registries debug messages.
Release Modification
12.2(53)SE2 This command was introduced.
Command Description
show controllers power inline Displays the values in the registers of the specified PoE controller.
show power inline Displays the power status for the specified PoE port or for all PoE
ports.
To Next Page
Loading...
Need help?
General
