B-64
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
debug platform messaging application
debug platform messaging application
Use the debug platform messaging application privileged EXEC command to enable debugging of
application messaging activity. Use the no form of this command to disable debugging.
debug platform messaging application {all | badpak | cleanup | events | memerr | messages |
stackchg | usererr}
no debug platform messaging application {all | badpak | cleanup | events | memerr | messages
| stackchg | usererr}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform messaging application command is the same as the no debug platform
messaging application command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable e
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
all Display all application-messaging debug messages.
badpak Display bad-packet debug messages.
cleanup Display clean-up debug messages.
events Display event debug messages.
memerr Display memory-error debug messages.
messages Display application-messaging debug messages.
stackchg Display stack-change debug messages.
This keyword is supported only on Catalyst 3750-X switches.
usererr Display user-error debug messages.
Release Modification
12.2(53)SE2 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
To Next Page
Loading...
Need help?
General
