Cisco Catalyst 3750-X

2-645
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
show idprom interface
show idprom interface
Use the show idprom user EXEC command to display the IDPROM information for the specified
interface.
show idprom interface interface-id [detail]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines This command applies only to 10-Gigabit Ethernet interfaces and to the SFP module interfaces.
Examples This is an example of output from the show idprom interface tengigabitethernet1/0/1 command for
the 10-Gigabit Ethernet interface.
Switch# show idprom interface tengigabitethernet1/0/1
X2 Serial EEPROM Contents:
Non-Volatile Register (NVR) Fields
X2 MSA Version supported :0xA
NVR Size in bytes :0x100
Number of bytes used :0x100
Basic Field Address :0xB
Customer Field Address :0x77
Vendor Field Address :0xA7
Extended Vendor Field Address :0x100
Reserved :0x0
Transceiver type :0x2 =X2
Optical connector type :0x0 =Unspecified
Bit encoding :0x1 =NRZ
Normal BitRate in multiple of 1M b/s :0x2848
Protocol Type :0x1 =10GgE
interface interface-id Display the IDPROM information for the specified interface.
detail (Optional) Display detailed hexidecimal IDPROM information.
Release Modification
12.2(53)SE2 This command was introduced.