Cisco Catalyst 3750-X Command Reference

2-85
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
channel-group
channel-group
Use the channel-group interface configuration command on the switch stack or on a standalone switch
to assign an Ethernet port to an EtherChannel group, to enable an EtherChannel mode, or both. Use the
no form of this command to remove an Ethernet port from an EtherChannel group.
channel-group channel-group-number mode {active | {auto [non-silent]} | {desirable
[non-silent]} | on | passive}
no channel-group
PAgP modes:
channel-group channel-group-number mode {{auto [non-silent]} | {desirable [non-silent}}
LACP modes:
channel-group channel-group-number mode {active | passive}
On mode:
channel-group channel-group-number mode on
Syntax Description channel-group-number Specify the channel group number. The range is 1 to 48.
mode Specify the EtherChannel mode.
active Unconditionally enable Link Aggregation Control Protocol (LACP).
Active mode places a port into a negotiating state in which the port initiates
negotiations with other ports by sending LACP packets. A channel is
formed with another port group in either the active or passive mode.
auto Enable the Port Aggregation Protocol (PAgP) only if a PAgP device is
detected.
Auto mode places a port into a passive negotiating state in which the port
responds to PAgP packets it receives but does not start PAgP packet
negotiation. A channel is formed only with another port group in desirable
mode. When auto is enabled, silent operation is the default.
desirable Unconditionally enable PAgP.
Desirable mode places a port into an active negotiating state in which the
port starts negotiations with other ports by sending PAgP packets. An
EtherChannel is formed with another port group that is in the desirable or
auto mode. When desirable is enabled, silent operation is the default.
non-silent (Optional) Use in PAgP mode with the auto or desirable keyword when
traffic is expected from the other device.
on Enable on mode.
In on mode, a usable EtherChannel exists only when both connected port
groups are in the on mode.
passive Enable LACP only if a LACP device is detected.
Passive mode places a port into a negotiating state in which the port
responds to received LACP packets but does not initiate LACP packet
negotiation. A channel is formed only with another port group in active
mode.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing