Cisco Catalyst 3750-X Command Reference

2-908
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
stack-power
stack-power
To configure StackPower parameters for the power stack or for a switch in the power stack, use the stack
power global configuration command. To return to the default setting, use the no form of the command,
stack-power {stack power stack name | switch switch-number}
no stack-power {stack-id name | switch switch-number}
Note This command is available only on Catalyst 3750-X switch stacks running the IP base or IP services
image.
Syntax Description
Defaults There is no default.
Command Modes Global configuration
Command History
Usage Guidelines When you enter the stack-power stack power stack name command, you enter power stack
configuration mode, and these commands are available:
• default: returns a command to its default setting.
• exit: exits ARP access-list configuration mode.
• mode: sets the power mode for the power stack. See the mode command.
• no: negates a command or returns to default settings.
If you enter the stack-power switch switch-number command with a switch number that is not
participating in stack power, you receive an error message.
When you enter the stack-power switch switch-number command with the number of a switch
participating in stack power, you enter switch stack power configuration mode, and these commands are
available:
• default: returns a command to its default setting.
• exit: exits switch stack power configuration mode.
• no: negates a command or returns to default settings.
stack power stack name Enter the power stack name. The name can be up to 31 characters. Entering
these keywords followed by a carriage return puts you in power stack
configuration mode.
switch switch-number Enter the switch number in the stack (1 to 4) to enter switch stack-power
configuration mode for the switch.
Release Modification
12.2(53)SE2 This command was introduced.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing