Cisco Catalyst 3750-X Command Reference

2-909
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
stack-power
• power-priority: sets the power priority for the switch and the switch ports. See the power-priority
command.
• stack-id name: enter the name of the power stack to which the switch belongs. If you do not enter
the power stack-ID, the switch does not inherit the stack parameters. The name can be up to 31
characters.
• standalone: Forces the switch to operate in standalone power mode. This mode shuts down both
stack power ports.
Examples This example removes switch 2, which is connected to the power stack, from the power pool and shutting
down both power ports.
Switch(config)# stack-power switch 2
Switch(config-switch-stackpower)# standalone
Switch(config-switch-stackpower)# exit
Related Commands Command Description
power inline Configures the power management mode for the specified PoE port or for all
PoE ports.
power-priority Sets the power priority for the switch and the switch ports.
show stack-power Displays parameters of the power stack.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing