Cisco Catalyst 3750-X Command Reference

2-119
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
clear rep counters
clear rep counters
To clear Resilient Ethernet Protocol (REP) counters for the specified interface or all interfaces, use the
clear rep counters privileged EXEC command
clear rep counters [interface interface-id]
Syntax Description
Defaults None
Command Modes Privileged EXEC
Command History
Usage Guidelines You can clear all REP counters by using the clear rep counters command, or you can clear only the
counters for the interface by using the clear rep counters interface interface-id command.
When you enter the clear rep counters command, only the counters visible in the output of the show
interface rep detail command are cleared. SNMP visible counters are not cleared because they are
read-only.
Examples This example shows how to clear all REP counters for all REP interfaces:
Switch# clear rep counters
You can verify that REP information was deleted by entering the show interfaces rep detail privileged
EXEC command.
Related Commands
interface interface-id (Optional) Specifies a REP interface whose counters should be cleared.
Release Modification
15.0(2)SE This command was introduced.
Command Description
show interfaces rep [detail] Displays detailed REP configuration and status information.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing