2-157
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
device-sensor filter-list
Use the number tlv-name keyword-argument pair to specify the TLV number to be added to the TLV
filter list.
Use the no tlv {name tlv-name | number tlv-number} command to remove individual TLVs from the
TLV filter list.
Use the no device-sensor filter-list lldp list tlv-list-name command to remove the entire TLV list
containing all of the TLVs.
The following example shows how to create an LLDP filter containing a list of TLVs:
Switch> enable
Switch# configure terminal
Switch(config)# device-sensor filter-list lldp list lldp-list
Switch(config-sensor-lldplist)# tlv name mac-phy-config
Switch(config-sensor-lldplist)# tlv name system-name
Switch(config-sensor-lldplist)# end
Examples The following example shows how to create an LLDP filter containing a list of TLVs:
Switch> enable
Switch# configure terminal
Switch(config)# device-sensor filter-list lldp list lldp-list
Switch(config-sensor-lldplist)# tlv name mac-phy-config
Switch(config-sensor-lldplist)# tlv name system-name
Switch(config-sensor-lldplist)# end
Table 2-2 LLDP TLVs
LLPP TLV Name Description
Global configuration mode
4-wire-power-management Cisco 4-wire power with MDI TLV
mac-phy-cfg IEEE 802.3 MAC/PHY configuration status TLV
management-address Management address TLV
port-description Port description TLV
port-vlan Port VLAN ID TLV
power-management IEEE 802.3 DTE power with MDI TLV
system-capabilities System capabilities TLV
system-description System description TLV
system-name System name TLV
Interface configuration mode
inventory-management LLDP Media Endpoint Devices (MED) inventory management TLV
location LLDP MED location TLV
network-policy LLDP MED network policy TLV