Cisco Catalyst 3750-X Command Reference

B-3
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
debug authentication
Defaults Authentication debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug authentication command is the same as the no debug authentication command.
On a 3750-E switch, when you enable debugging, it is enabled only on the stack master.
To enable debugging on a stack member, you can start a session from the stack master by using the
session switch-number privileged EXEC command and then entering the debug authentication
command at the command-line prompt of the stack member. You also can use the remote command
stack-member-number line privileged EXEC command on the stack master switch to enable debugging
on a stack member.
Related Commands
Release Modification
12.2(53)SE2 This command was introduced.
Command Description
authentication
control-direction
Configures the port mode as unidirectional or bidirectional.
authentication
event
Sets the action for specific authentication events.
authentication
fallback
Configures a port to use web authentication as a fallback method for clients that
do not support IEEE 802.1x authentication.
authentication
host-mode
Sets the authorization manager mode on a port.
authentication open Enables or disables open access on a port.
authentication
order
Sets the order of authentication methods used on a port.
authentication
periodic
Enables or disables reauthentication on a port.
authentication
port-control
Enables manual control of the port authorization state.
authentication
priority
Adds an authentication method to the port-priority list.
authentication
violation
Configures the violation modes that occur when a new device connects to a port
or when a new device connects to a port after the maximum number of devices
are connected to that port.
show
authentication
Displays information about authentication manager events on the switch.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing