Cisco Catalyst 3750-X Command Reference

2-82
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
boot system
When you enter the boot system switch number or the boot system switch all command on the stack
master, the stack master checks if a software image is already on the stack member (except on the stack
master). If the software image does not exist on the stack member (for example, stack member 1), an
error message like this appears:
%Command to set boot system switch all xxx on switch=1 failed
When you enter the boot system switch number command on the stack master, you can specify only one
stack member for the number variable. Entering more than one stack member for the number variable is
not supported.
If you are using the archive download-sw privileged EXEC command to maintain system images, you
never need to use the boot system command. The boot system command is automatically manipulated
to load the downloaded image.
This command changes the setting of the BOOT environment variable. For more information, see
Appendix A “Catalyst 3750-X and 3560-X Switch Boot Loader Commands.”
Related Commands Command Description
show boot Displays the settings of the boot environment variables.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing