Cisco Catalyst 3750-X Command Reference

B-104
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
debug sw-vlan vtp
Usage Guidelines The undebug sw-vlan vtp command is the same as the no debug sw-vlan vtp command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
If no further parameters are entered after the pruning keyword, VTP pruning debugging messages
appear. They are generated by the VTP_PRUNING_LOG_NOTICE, VTP_PRUNING_LOG_INFO,
VTP_PRUNING_LOG_DEBUG, VTP_PRUNING_LOG_ALERT, and
VTP_PRUNING_LOG_WARNING macros in the VTP pruning code.
Related Commands Command Description
show debugging Displays information about the types of debugging that are enabled.
show vtp Displays general information about VTP management domain, status, and
counters.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing