Cisco Catalyst 3750-X - Page 1237

Index
IN-17
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
replay protection, MACsec 2-539
replay-protection command 2-539
rep lsl-age-timer command 2-530
rep preempt delay command 2-531
rep preempt segment command 2-533
rep segment command 2-534
rep stcn command 2-537
reset (boot loader) command A-22
restricted VLAN
See dot1x auth-fail vlan
rmdir (boot loader) command
A-23
rmon collection stats command 2-541
root guard, for spanning tree 2-863
routed ports
IP addresses on
2-241
number supported 2-241
routing frames
See MTU
RPS
See Cisco Redundant Power System 2300
RPS 2300
configuring
2-492, 2-498, 2-500
managing 2-492, 2-498, 2-500
See Cisco Redundant Power System 2300
RSPAN
configuring
2-433
displaying 2-769
filter RSPAN traffic 2-433
remote-span command 2-521
sessions
add interfaces to
2-433
displaying 2-769
start new 2-433
rsu command 2-542
S
scheduled switchover
disabling
2-167
enabling 2-167
SDM mismatch mode 2-544, 2-811
sdm prefer command 2-543
SDM templates
allowed resources
2-545
and stacking 2-544
displaying 2-795
dual IPv4 and IPv6 2-543
secure ports, limitations 2-941
sending flow-control packets 2-226
service password-recovery command 2-547
service-policy command 2-549
session command 2-552
set (boot loader) command A-24
set command 2-553
setup command 2-555
setup express command 2-558
show access-lists command 2-560
show archive status command 2-563
show arp access-list command 2-564
show authentication command 2-565
show auto qos command 2-569
show boot command 2-573
show cable-diagnostics tdr command 2-576
show cisp command 2-579
show class-map command 2-580
show cluster candidates command 2-583
show cluster command 2-581
show cluster members command 2-585
show controllers cpu-interface command 2-587
show controllers ethernet-controller command 2-589
show controllers ethernet-controller fastethernet
command
2-597
show controllers ethernet phy macsec command 2-600
show controllers power inline command 2-602
show controllers tcam command 2-604
show controller utilization command 2-606
show device-sensor cache command 2-608
show dot1q-tunnel command 2-615
show dot1x command 2-616