Cisco Catalyst 3750-X Command Reference

2-135
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
cluster standby-group
This example shows the error message when this command is executed on a cluster command switch and
the specified HSRP standby group does not exist:
Switch(config)# cluster standby-group my_hsrp
%ERROR: Standby (my_hsrp) group does not exist
This example shows the error message when this command is executed on a cluster member switch:
Switch(config)# cluster standby-group my_hsrp routing-redundancy
%ERROR: This command runs on a cluster command switch
You can verify your settings by entering the show cluster privileged EXEC command. The output shows
whether redundancy is enabled in the cluster.
Related Commands Command Description
standby ip Enables HSRP on the interface. For syntax information, select Cisco IOS IP
Command Reference, Volume 1 of 3:Addressing and Services,
Release 12.2 > IP Services Commands.
show cluster Displays the cluster status and a summary of the cluster to which the switch
belongs.
show standby Displays standby group information. For syntax information, select Cisco
IOS IP Command Reference, Volume 1 of 3:Addressing and Services,
Release 12.2 > IP Services Commands.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing