Cisco Catalyst 3750-X Command Reference

2-497
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
power xps (global configuration)
Naming conflicts can occur when multiple data-stacked switches are connected to the same XPS. To
avoid conflicts, configure the name only for the lowest switch number in the stack that is connected to
the XPS. The show commands display only the name configured for the lowest switch number in the
stack that is connected to the XPS. Other configured names are stored in the config.text file, but are
ignored in the show command outputs.
You can verify your settings by entering the show env xps configuration or show env xps port
privileged EXEC command.
Examples This example shows how to configure the name of the XPS 2200 that is connected to a Catalyst 3750-X
switch stack in a stack as a accounting:
Switch> power xps 2 name accounting
This example shows how to configure the name of an XPS 2200 that is connected to a Catalyst 3560-X
switch as the serial number of the XPS:
Switch> power xps name serialnumber
This example shows how to configure the name of XPS port 1 as switcha:
Switch> power xps port 1 switcha
Related Commands Command Description
power xps (privileged
EXEC command)
Configures XPS ports and power supplies.
show env xps [system] Displays the status of the XPS connected to a switch or switch stack,
including the names of the ports and XPS.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing