Cisco Catalyst 3750-X

2-501
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
power xps port
Usage Guidelines The priority setting applies only to RPS mode. You configure stack power priority for the system and for
high and low-priority ports by using the power-priority switch, power-priority high, and
power-priority low commands in switch stack power configuration mode.
You can verify your settings by entering the show env xps power or show env xps configuration
privileged EXEC command.
Examples This example shows how to set power supply A to RPS mode:
Switch> power xps supply A mode RPS
This example shows how to set power supply B to stack power mode when the XPS is connected to stack
member 2
Switch> power xps 2 supply B mode SP
Related Commands Command Description
power xps (global
configuration
command)
Configures XPS and XPS port names.
show env xps Displays the status of the XPS connected to a switch or switch stack.