Cisco Catalyst 3750-X Command Reference

2-548
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
service password-recovery
Note If you use the no service password-recovery command to control end user access to passwords, we
recommend that you save a copy of the config file in a location away from the switch in case the end user
uses the password recovery procedure and sets the system back to default values. Do not keep a backup
copy of the config file on the switch.
If the switch is operating in VTP transparent mode, we recommend that you also save a copy of the
vlan.dat file in a location away from the switch.
When you enter the service password-recovery or no service password-recovery command on the
stack master, it is propagated throughout the stack and applied to all switches in the stack.
You can verify if password recovery is enabled or disabled by entering the show version privileged
EXEC command.
Examples This example shows how to disable password recovery on a switch or switch stack so that a user can only
reset a password by agreeing to return to the default configuration.
Switch(config)# no service-password recovery
Switch(config)# exit
Related Commands Command Description
show version Displays version information for the hardware and firmware.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing