Cisco Catalyst 3750-X Command Reference

2-648
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
show interfaces
Note Though visible in the command-line help strings, the crb, fair-queue, irb, mac-accounting,
precedence, random-detect, rate-limit, and shape keywords are not supported.
Command Modes Privileged EXEC
Command History
Usage Guidelines The show interfaces capabilities command with different keywords has these results:
• On Catalyst 3750-X switches, use the show interface capabilities module number command to
display the capabilities of all interfaces on that switch in the stack. If there is no switch with that
module number in the stack, there is no output.
• On Catalyst 3560-X switches, use the show interface capabilities module 1 command to display
the capabilities of all interfaces on the switch. Any other number is invalid.
• Use the show interfaces interface-id capabilities to display the capabilities of the specified
interface.
• On Catalyst 3750-X switches, use the show interfaces capabilities (with no module number or
interface ID) to display the capabilities of all interfaces in the stack.
• On Catalyst 3560-X switches, use the show interfaces capabilities (with no module number or
interface ID) to display the capabilities of all interfaces on the switch.
• On Catalyst 3750-X switches, use the show interface switchport module number command to
display the switch port characteristics of all interfaces on that switch in the stack. If there is no
switch with that module number in the stack, there is no output.
• On Catalyst 3560-X switches, use the show interface switchport module 1 to display the switch
port characteristics of all interfaces on the switch. Any other number is invalid.
Examples This is an example of output from the show interfaces command for an interface on stack member 3:
Switch# show interfaces gigabitethernet3/0/2
GigabitEthernet3/0/2 is down, line protocol is down
Hardware is Gigabit Ethernet, address is 0009.43a7.d085 (bia 0009.43a7.d085)
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
backup (Optional) Display Flex Link backup interface configuration and status for
the specified interface or all interfaces on the switch or the stack.
tengigabitethernet Display the status of a connected ten-gigabit module.
transceiver [detail |
properties |
dom-supported-list]
See the show interfaces transceivers command.
trunk Display interface trunk information. If you do not specify an interface, only
information for active trunking ports appears.
Release Modification
12.2(53)SE2 This command was introduced.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing