2-778
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
show nmsp
This is an example of output from the show nmsp notification interval command:
Switch# show nmsp notification interval
NMSP Notification Intervals
----------------------------------
Attachment notify interval: 30 sec (default)
Location notify interval: 30 sec (default)
This is an example of output from the show nmsp statistics connection and show nmsp statistics
summary commands:
Switch# show nmsp statistics connection
NMSP Connection Counters
----------------------------------
Connection 1:
Connection status: UP
Freed connection: 0
Tx message count Rx message count
----------------------- -----------------------
Subscr Resp: 1 Subscr Req: 1
Capa Notif: 1 Capa Notif: 1
Atta Resp: 1 Atta Req: 1
Atta Notif: 0
Loc Resp: 1 Loc Req: 1
Loc Notif: 0
Unsupported msg: 0
Switch# show nmsp statistics summary
NMSP Global Counters
----------------------------
Send too big msg: 0
Failed socket write: 0
Partial socket write: 0
Socket write would block: 0
Failed socket read: 0
Socket read would block: 0
Transmit Q full: 0
Max Location Notify Msg: 0
Max Attachment Notify Msg: 0
Max Tx Q Size: 0
This is an example of output from the show nmsp status command:
Switch# show nmsp status
NMSP Status
----------------
NMSP: enabled
MSE IP Address TxEchoResp RxEchoReq TxData RxData
172.19.35.109 5 5 4 4
These are examples of output from the show nmsp show subscription detail and the show nmsp show
subscription summary commands:
Switch# show nmsp subscription detail
Mobility Services Subscribed by 172.19.35.109:
Services Subservices
----------------- -------------------
Attachment: Wired Station
Location: Subscription