44-22
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 44 Configuring Network Admission Control
Configuring Network Admission Control with LAN Port IP
Adding IP Addresses to Existing Policy Groups
This command allows you to add an IP address to an existing policy group. The command fails if the
group name is not already present in the group database.
To add an IP address to an existing policy group, perform this task in privileged mode:
This example shows how to add an IP address to an existing policy group:
Console> (enable) set policy group grp1 ip-address 100.1.1.1 255.255.255.255
Added IP 100.1.1.1/255.255.255.255 to policy group grp1.
Console> (enable)
Adding a Policy Group to the Policy Template
You can add a policy group to the policy template. If a policy template does not exist, it is created.
Similarly, if the policy group name does not exist, it is created.
To add a policy group to the policy template, perform this task in privileged mode:
This example shows how to add a policy group to the policy template:
Console> (enable) set policy name pol1 group grp1
Added group grp1 to policy template pol1.
Console> (enable)
Clearing an IP Address from a Policy Group
To clear an IP address from a policy group, perform this task in privileged mode:
This example shows how to clear an IP address from a policy group:
Console> (enable) clear policy group grp1 ip-address 100.1.1.1
Cleared IP 100.1.1.1 from policy group grp1.
Console> (enable)
Task Command
Add an IP address to an existing policy group. set policy group group-name ip-address ip-address
Task Command
Add a policy group to the policy template. set policy name policy-name group group-name
Task Command
Clear an IP address from a policy group. clear policy group group-name ip-address
ip-address
To Next Page
Loading...
Need help?
General