15-101
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 15 Configuring Access Control
Configuring Policy-Based Forwarding
set security acl ip ip1 permit arp
set security acl ip ip1 redirect a_1 ip host 44.0.0.1 host 43.0.0.1
set security acl ip ip1 redirect a_2 ip host 44.0.0.2 host 43.0.0.2
set security acl ip ip1 redirect a_3 ip host 44.0.0.3 host 43.0.0.3
set security acl ip ip1 redirect a_4 ip host 44.0.0.4 host 43.0.0.4
set security acl ip ip1 permit ip any any
#ip2
set security acl ip ip2 permit arp
set security acl ip ip2 redirect b_1 ip host 43.0.0.1 host 44.0.0.1
set security acl ip ip2 redirect b_2 ip host 43.0.0.2 host 44.0.0.2
set security acl ip ip2 redirect b_3 ip host 43.0.0.3 host 44.0.0.3
set security acl ip ip2 redirect b_4 ip host 43.0.0.4 host 44.0.0.4
set security acl ip ip2 permit ip any any
#pbf set
set pbf mac 00-11-22-33-44-55
#
commit security acl all
set security acl map ip1 1
set security acl map ip2 2
This example shows how to display the MAC addresses that were learned by the switch for port 6/17 on
VLAN 1:
Console> (enable) show cam dynamic 6/17
* = Static Entry. + = Permanent Entry. # = System Entry. R = Router Entry.
X = Port Security Entry $ = Dot1x Security Entry
VLAN Dest MAC/Route Des [CoS] Destination Ports or VCs / [Protocol Type]
---- ------------------ ----- -------------------------------------------
1 00-20-20-20-20-23 6/17 [ALL]
1 00-20-20-20-20-22 6/17 [ALL]
1 00-20-20-20-20-21 6/17 [ALL]
1 00-20-20-20-20-20 6/17 [ALL]
1 00-20-20-20-20-27 6/17 [ALL]
1 00-20-20-20-20-26 6/17 [ALL]
1 00-20-20-20-20-25 6/17 [ALL]
1 00-20-20-20-20-24 6/17 [ALL]
1 00-20-20-20-20-2b 6/17 [ALL]
1 00-20-20-20-20-2a 6/17 [ALL]
1 00-20-20-20-20-29 6/17 [ALL]
1 00-20-20-20-20-28 6/17 [ALL]
1 00-20-20-20-20-2f 6/17 [ALL]
1 00-20-20-20-20-2e 6/17 [ALL]
1 00-20-20-20-20-2d 6/17 [ALL]
1 00-20-20-20-20-2c 6/17 [ALL]
Total Matching CAM Entries Displayed for 6/17 = 16 for port 6/9, vlan 2
To Next Page
Loading...
Need help?
General