v2.13 Cleverscope CS300 Reference Manual
©Cleverscope 2004-2018 www.cleverscope.com Page 13
Modules
Upgrade to 8MSample memory
External Sampler Clock Interface
100MHz 10 bit dual channel sampler
100MHz 12 bit dual channel sampler
100MHz 14 bit dual channel sampler
USB 2.0 PC Interface module
Ethernet Interface module
Signal Generator (0 – 10 MHz, Sine, Square, Triangle)
Sine Wave Generator 300Vrms isolated (0 – 65MHz, sine)
Power Amplifier, stand-alone. 50 MHZ Bandwidth, 1A drive current, +/-17V output sine
wave or DC value (using supplied 19V supply) which maybe offset from 0V to +17V by
using a higher voltage input supply (20V - 36V). With a 36V supply the output swings 0 -
34V.
Accessories
CS1001 Analog Probe - 1x, 10x 250MHz
CS1002 Analog Probe – 100x 250MHz
CS1003 Analog Probe - 1000x, 50MHz
CS1004 Digital Probe Pod – 4bit 100MHz (including probe clips) Colour-coded ports 1-4
CS1004 Digital Probe Pod – 4bit 100MHz (including probe clips) Colour-coded ports 5-8
CS1010 50 5ns delay line to connect Channel A to Channel B for 200MSample operation
CS1020 2 port link cable to connect two Cleverscope units for four channel operation
CS1030 Differential Probe 25MHz 1300v
CS1031 Differential Probe 50MHz 6500v
CS1041 USB Isolator
CS1050 Power Supply without 230/110v cable
CS1060 70Amp AD Dc current Probe
Probe sets come complete with the probe tip accessories, compensation adjusting tool, and channel Identifying
clips. Each probe packet includes a frequency response chart.
Upgrades
Upgrades are normally specified at time of ordering and supplied installed ex-factory.
Some modules can be retro-fitted in the field by qualified personnel using antistatic facilities and appropriate
tools. Full instructions are provided by Cleverscope.
Configurations
Cleverscopes are defined by their configuration ID in the form of mem.sps.bit.sig.io where
Speed in 10MSPS unit, 100MSPS = 10
0 not fitted, 1 CS700A fitted 2 701 fitted
To Next Page
Loading...