Cleverscope CS300 - SPI Tab

Cleverscope CS300 Reference Manual v2.11
Page 142 www.cleverscope.com ©Cleverscope 2004-2015
21.2 SPI Tab
SPI Protocol Options Tab
Name
Displays the Name as set in the Protocol List.
SPI Data Channel
Analog Threshold
Click on the up or down arrow or in the field to select the input connected to the data
stream.
Click on the up or down arrow or in the field to set the threshold value.
SPI Clk Channel
Analog Threshold
Click on the up or down arrow or in the field to select the input connected to the clock.
Click on the up or down arrow or in the field to select threshold value.
SPI CS Channel
Analog Threshold
Click on the up or down arrow or in the field to select the input connected to the CS
signal.
Click on the up or down arrow or in the field to select threshold value.
SPI MSB First
Click the button to toggle the switch to recognise MSB or LSB first in the data stream.
SPI CS Active
Click on the up or down arrow or in the field to select the CS signal active state (‘0’ or
‘1’).
SPI Invert Data
Click the button to toggle the switch to invert data signals.
SPI Clock Edge
Click the button to toggle the switch to select the active clock edge.
Bit time
Click on the up or down arrow or in the field to select likely bit time.
Copy to Notes
Click the button to toggle the switch to copy the results to notes.