Cleverscope CS300 Reference Manual v2.11
Page 170 www.cleverscope.com ©Cleverscope 2004-2015
25.9 Ethernet Cleverscope Firmware Update
To update the firmware in an
Ethernet Cleverscope
click Choose USB/Ethernet. In Interface Source select
Ethernet – Find by IP address
. Click on the
Cleverscope
to program in the list, and proceed as above.
25.10 Update a First Generation Installation
If your application version number begins with 3.2 or 3.3, you have an old run time library. You will need to do
a new install to obtain the new run time library.
Please carry out the following steps:
Rename the ‘Cleverscope’ program files folder to ‘Clevesrcope_old’. Do not un-install the old application.
Carry out the steps in 25.2 Cleverscope Application Software First Time above.
Update the firmware in your
Cleverscope
by following the steps in 25.8 Firmware Update.
If you are one of the very few customers with a
Cleverscope
with a serial number beginning with ‘A00’ please
contact Cleverscope at support@cleverscope.com before attempting an upgrade.
25.11 Using Windows 98SE, ME and NT
If you use Windows 98SE, ME or NT you will need to download the correct installation or update from the
Cleverscope website. You can find these at www.cleverscope.com/resources/. These operating systems are no
longer supported, and are only available for the
CS328 Classic
.
To Next Page
Loading...