Cleverscope CS300 Reference Manual v2.11
Page 188 www.cleverscope.com ©Cleverscope 2004-2015
30 Appendix 2 - Keyboard Shortcuts
As well as using the mouse to navigate and control Cleverscope there are a number of keyboard shortcuts that
can be used to save time and improve ergonomics. These are described below:
Movement:
and move the cursor left and right
Shift + and move the graph left and right
Ctrl + and change the x-scale up or down
and move the selected graph up and down
Shift + and move the selected graph up and down
Ctrl + and change the y-scale up and down
Markers:
1 and 2 set markers one and two
Spacebar sets the next marker
Graph Viewing:
Tab swaps channels
A autoscales the graphs
PageDown zooms in on the tracer
PageUp zooms out on the tracer
L locks the tracking display position on the current scope display tracer position
F10 automatically sets the graph scales and trigger settings
Control:
C or Ctrl + C copies the graph to the clipboard
X or Ctrl + X clears the graph
P or Ctrl + P prints the graph
F1 chooses the Pan/Tracer cursor
F2 chooses the Annotation cursor
F3 chooses the Rising Trigger cursor
F4 chooses the Falling Trigger cursor
Sampling:
F7 initiates a single acquisition
F8 initiates automatic acquisition
F9 initiates triggered acquisition
Mouse Wheel:
The mouse wheel acts as a virtual knob on whatever control was last selected. So if you select the Chan A
Contract button, and then use the Mouse Wheel, the wheel acts as a virtual knob on the Channel A Volts/div.
Note You can copy the keyboard shortcut control list from the About Cleverscope window and paste wherever
it is helpful for you.
To Previous Page
Loading...