Cleverscope CS300 - UART Tab

v2.13 Cleverscope CS300 Reference Manual
©Cleverscope 2004-2018 www.cleverscope.com Page 141
21.1 UART Tab
UART Protocol Options Tab
Name
Displays the Name as set in the Protocol List.
Ser Data Channel
Click on the up or down arrow or in the field to select which input is connected to the
data stream.
Ser Analog Threshold
Click on the up or down arrow or in the field to set the threshold value.
Ser Num Bits
Click on the up or down arrow or in the field to select the number of data bits.
Ser parity used
Click the button to toggle the switch to ‘used’ if the data stream uses a parity bit.
Ser MSB first
Click the button to toggle the switch to set MSB or LSB first.
Ser Idle high
Click the button to toggle the switch to set Idle high or Idle low value.
Ser Bit time
Click on the up or down arrow or in the field to select serial bit time OR
Baud rate
Click on the up or down arrow or in the Baud rate field to select the Baud rate. Setting
the Baud rate will automatically populate the Serial Bit Time value.
Copy to Notes
Click the button to toggle the switch to copy the results to notes.