Cleverscope CS300 Reference Manual v2.11
Page 14 www.cleverscope.com ©Cleverscope 2004-2015
3 Getting Started
The Cleverscope is easy to set up and get running once the Cleverscope application software is installed on your
PC.
3.1 Unpack
Cleverscopes are normally supplied as a boxed kit containing the Cleverscope Acquisition Unit, power supply
and power cable, two 1x/10x 250MHz probes, installation Instructions, a Cleverscope Application Software
CDROM, and digital probe sets for the digital versions.
Unpack the box, remove wrapping and discard safely.
3.2 Install Cleverscope Application Software
The Cleverscope Application Software is supplied on the CD that came with the unit.
Install the software by following the instructions on the printed sheet. Do not plug in the Cleverscope while
installing the software.
Minimum requirements are a Pentium PC with at least 256 MB of memory running Windows 7, Windows Vista,
Windows XP or Windows 2000.
3.3 Power up the Cleverscope Acquisition Unit (CAU)
Connect the DC power cable to
POWER IN
, socket on the rear panel.
Note: When you plug the power adapter into the mains the Trig indicator should blink and the Power indicator
should show a steady green. This is the self test completing.
Plug the power adaptor into the mains. Observe the green power light.
3.4 Connect the CAU to the PC - USB
Connect the USB cable to
USB
port
on the rear of the unit
and to the PC.
Note If this is the first time of use, there will be a small delay while Windows finds the drivers.
3.5 Connect the CAU to the PC - Ethernet
For an Ethernet CAU connect the Ethernet cable to the Ethernet port on the rear of the unit and to the
PC/switch/network.
Check the indicator lights on the Ethernet port are illuminated.
To Next Page
Loading...