Cleverscope CS300 Reference Manual v2.11
Page 22 www.cleverscope.com ©Cleverscope 2004-2015
4 Cleverscope Control Panel
The Cleverscope Application software provides a Control Panel to setup and control signal acquisition. A
number of display windows show alternative but simultaneous views of signal and spectrum data. It also has
additional windows that control the way the signal data is processed and displayed as well as controls for the
optional CS700A Signal Generator.
The Cleverscope Control Panel contains all of the controls and menu items for capturing, and saving signal data.
Note You can individually size and position each window to optimize the ease of use and views of signal and
spectrum data.
Control Panel
Minimise Control Panel
Close Control Panel
TOOLS zone
DISPLAY zone
ACQUIRE zone
TRIGGER 1 zone
TRIGGER 1~2 zone
Decode Protocol zone
Normally displayed when the Cleverscope Application is
started.
Click minimise icon.
Click the X button to Exit Cleverscope and close all windows.
Selects application wide tools.
Settings for signal data storage and display.
Settings for signal acquisition.
Trigger settings for Trigger 1.
Trigger settings for Trigger 1 and 2.
Protocol decode settings.
4.1 Cleverscope Tools Zone [Control Panel]
The Cleverscope Tools zone contains controls that apply to all Cleverscope displays. Buttons are used to activate
the controls to pan a graph, zoom it, annotate it, adjust floating markers, or set the trigger level.
Cleverscope Tools Zone buttons
The ‘Hand Tool” (‘grabbing tool’) or Pan cursor tool is used to pan the graph by dragging
anywhere inside the graph to move it into the desired position.
Click on the ‘grabbing hand’ tool button. Move the mouse cursor on to the display.
Hold down the left mouse button and drag the screen to move it.
The Horizontal Expand cursor tool is used to horizontally expand the graph section in which
it is used. Click on the ‘Horizontal Expand’ tool button. Move the mouse cursor on to the
display, at the point you want to expand.
Click and hold down the Left mouse button to drag the section line left or right to highlight
the area to be zoomed. Release the left button, and the selection will expand to fit the
screen. Use the Back History button to undo the change.
The Vertical Expand cursor tool is used to vertically expand the graph section in which it is
used. Click on the Vertical Expand tool button. Move the mouse cursor on to the display at
the point you would like to expand.
To Next Page
Loading...