10-6 Preventive Maintenance
9. Clean any dust or other contaminants from the nosepiece.
10. Wait for the thermal print head and nosepiece to dry thoroughly.
If you need to reload the color ribbon, go to step 11. Otherwise
go to step 13.
TIP:
Cleaning the platen and donor guide bar while the top cover is open
If you want to clean the platen and donor guide bar while the imager is already open, refer
to steps 7 through 12 in the procedure in “Cleaning the Platen and Donor Guide Bar” on
page 10-8.
11. To reload the color ribbon, go to the Move Ribbon Carriage
menu and press the key to move the ribbon carriage up so
you can reload the ribbon.
CAUTION
Use only the print head cleaning wipe when cleaning the thermal print
head. Also, do not touch the glass surface of the thermal print head with your fingers;
it could damage the print head. To avoid touching the glass surface, you may want to
wear gloves when cleaning the thermal print head.
CAUTION
The thermal print head
must
be completely dry before attempting to use
the imager. Allowing the thermal print head to heat up again while still wet will damage
the thermal print head.
/
To Next Page
Loading...
