User's Manual
259
Make sure that the remote device, such as IPC, has been added. See "5.4.2 Adding Remote Device"
for detailed information.
Step 1 Click
Actions, and then select Record.
Figure 8-37 Record
Step 2 Set the time length of recording after the event moment.
Step 3 (Optional) Repeat Step 1–Step 2 to link multiple remote devices to record.
8.4.1.2 Buzzer
The system activates a buzzer alarm when there is corresponding alarm event.
Click Actions and select Buzzer to enable this function.
Figure 8-38 Buzzer
8.4.1.3 Log
Enable the log function. The system notes down the alarm information in the log when there is
corresponding alarm event.
Click
Actions and select Log to enable this function.
Figure 8-39 Log
When log function is enabled, after an alarm is triggered, click on LIVE page, select MAINTAIN >
Log > Event.
8.4.1.4 Email
Enable Email function. The system sends alarm email to all added receivers when there is
corresponding alarm event.
Make sure that the email configuration has been completed. See "8.3.2.3 Email" for detailed
information.
Click Actions and select Email to enable this function.
To Next Page
Loading...
Need help?
General
