User's Manual
251
Table 8-12 SNMP parameters
Port Listening port of agent programs on the device.
Read Community, Write
Community
Read or Write Community supported by the agent programs.
The name can only contain numbers, letters, underscores, and
middle lines.
Trap Server
The destination address of Trap information sent by the agent
program.
Trap Port The destination port of Trap information sent by the agent program.
Read Only User
Set the username the read-only user. The read-only user can only
have the read-only permission.
The name can only contain numbers, letters, and underscores.
Read Authentication
Type
You can select MD5 or SHA. It is MD5 by default.
Read Authentication
Password
The password must contain at least 8 digits.
Read Encryption Type CFB-AES by default.
Read Encryption
Password
The password must contain at least 8 digits.
Read/Write User
The username is private by default. If you log in using this username,
you have the read-and-write permission.
The name can only contain numbers, letters, and underscores.
R/W Authentication Type You can select MD5 or SHA. It is MD5 by default.
R/W Authentication
Password
The password must contain at least 8 digits.
R/W Encryption Type CFB-AES by default.
R/W Encryption
Password
The password must contain at least 8 digits.
Step 5 Click Save.
8.3.2.5 Register
Register the device on designated proxy server, and client software visits the device through the
proxy server.
Step 1 Click , or click on the configuration page, and then select
NETWORK > Network
Apps > Register.
To Next Page
Loading...
Need help?
General
