User's Manual
275
The parameters might be different depending on the model you purchased.
8.4.3.1 Video Detection
Video detection function adopts the PC visual, image and graphical processing technology to
analyze the video image and check there is considerable changes on the video. Once there are
considerable video changes (such as there is any moving object, or the video is blurred), system
triggers corresponding alarm event.
8.4.3.1.1 Configuring Video Motion
After analyzing video, system can generate a video motion alarm when the detected moving target
reaches the sensitivity you set here.
Step 1 Click , or click on the configuration page, and then select
EVENT.
Step 2 Select remote device in the device tree on the left.
Step 3 Select Video Detect > Video Motion.
Figure 8-61 Video motion
Step 4 Click to enable video motion detection.
Step 5 Set parameters.
Table 8-22 Motion detect parameters description
Debouncing System only records one alarm event during the debouncing period.
Exclude PTZ control
After enabling exclude PTZ control, system does not trigger an alarm
when you are manually control the PTZ.
It is for PTZ camera only.
Step 6 Set motion detection region.
System supports maximum four detection zones. After setting, once there is an alarm from
any of these four zones, the remote device triggers an alarm.