User's Manual
49
Figure 5-14 Initialize
Step 9 Click Confirm and Add, or click OK.
●
Click
Confirm and Add: System completes initializing the remote device and then adds
the remote device to the list. System goes back to Add device page.
●
Click
OK: System completes initializing remote device. System goes back to Add device
page.
5.4.2 Adding Remote Device
Device supports smart add, manual add and template add.
Table 5-7 Add mode
Smart Add
Search the remote devices on the same network and then filter
to register. For details, see "5.4.2.1 Smart Add".
It is useful if you do not know the exact IP address.
Manual Add
Enter the IP address, username and password of remote device.
For details, see "5.4.2.2 Manual Add".
For some remote devices, you can enter IP address, username,
and password to register.
RTSP
Add remote devices through RTSP. For details, see "5.4.2.3 RTSP
".
To add stream media devices, you are recommended to choose
RTSP.