User's Manual
48
Figure 5-13 Modify IP
Step 7 Set camera IP address.
●
When there is DHCP server in the network, select DHCP, and the remote device gets
dynamic IP address automatically. It is unnecessary to enter IP address, subnet mask
and gateway.
●
Select
Static, and then enter static IP address, subnet mask, default gateway and
incremental value.
●
After you input incremental value, system can add the fourth address of the IP address
one by one to automatically allocate the IP addresses.
●
If you want to change several devices IP addresses at the same time, system allocates IP
address of the same network segment.
●
If there is IP conflict when changing static IP address, device pops up IP conflict
dialogue box. If batch change IP address, device automatically skips the conflicted IP
and begins the allocation according to the incremental value.
Step 8 Click
Next.
System begins initializing remote device.
To Next Page
Loading...
Need help?
General
