User's Manual
46
Using current device password and password protection information is enabled by
default. Keep it enabled so as to automatically use current device admin password and
email without manual configuration. Go to Step 6 if you keep it enabled.
1) To manually configure password, click to disable Using current device password
and password protection information.
Figure 5-11 Password setting
2) Set parameters.
Table 5-6 Description of password parameters
Username The default username is admin.
Password In the
box, enter the new password and enter it again
in the Confirm Password box.
The new password can be set from 8 characters through 32 characters
and contains at least two types from number, letter and special
characters (excluding '";:& and space). Enter a strong password
according to the password strength indication.
Confirm Password
3) Click Next.