Dasan V8102 - Page 70

UMN:CLI User Manual
V8102
70
privilege interface level <0-15> {COMMAND |
all}
Uses the specific command of Interface
Configuration mode in the level.
privilege vrrp level <0-15> {COMMAND | all}
Uses the specific command of VRRP Con-
figuration mode in the level.
privilege rip level <0-15> {COMMAND | all}
Uses the specific command of RIP Configu-
ration mode in the level.
privilege bgp level <0-15> {COMMAND | all}
Uses the specific command of BGP Config-
uration mode in the level.
privilege ospf level <0-15> {COMMAND | all}
Uses the specific command of OSPF Con-
figuration mode in the level.
privilege flow level <0-15> {COMMAND | all}
Uses the specific command of Flow Config-
uration mode in the level.
privilege policer level <0-15> {COMMAND |
all}
Uses the specific command of Policer Con-
figuration mode in the level.
privilege policy level <0-15> {COMMAND |
all}
Uses the specific command of Policy Con-
figuration mode in the level.
privilege {rmon-alarm level| rmon-event|
rmon-history} <0-15> {COMMAND | all}
Uses the specific command of RMON Con-
figuration mode in the level.
privilege dhcp-pool level
<0-15> {COMMAND | all}
Uses the specific command of DHCP Pool
Configuration mode in the level.
privilege dhcp-pool-class level <0-15>
{COMMAND | all}
Uses the specific command of DHCP Pool
Class Configuration mode in the level.
privilege dhcp-option82 level <0-15> {COM-
MAND | all}
Uses the specific command of DHCP Op-
tion 82 Configuration mode in the level.
privilege dhcp-class level <0-15> {COM-
MAND | all}
Uses the specific command of DHCP Class
Configuration mode in the level.
privilege route-map level <0-15> {COMMAND
| all}
Uses the specific command of Route-map
Configuration mode in the level.
privilege nacl-ip-std level <0-15> {COM-
MAND | all}
Global
Uses the specific command of IP Access-
List Extended Configuration mode in the
level.
privilege nacl-ip-ext level <0-15> {COM-
MAND | all}
Uses the specific command of IP Access-
List Standard Configuration mode in the
level.
privilege nacl-mac-ext level <0-15> {COM-
MAND | all}
Uses the specific command of MAC Ac-
cess-List Extended Configuration mode in
the level.
privilege nd-acl level <0-15> {COMMAND |
all}
Uses the specific command of IPv6 ND
Access-List Configuration mode in the level.
privilege ra-pol level <0-15> {COMMAND |
all}
Uses the specific command of IPv6 ND
Raguard Policy Configuration mode in the
level.
privilege sflow-receiver level <0-15> {COM-
MAND | all}
Uses the specific command of sFlow Re-
ceiver Configuration mode in the level.
privilege slowpath-filter level <0-15> {COM-
MAND | all}
Uses the specific command of Slowpath
Filter Configuration mode in the level.