Dasan V8102 - Page 71

User Manual UMN:CLI
V8102
71
The commands that are used in low level can be also used in the higher level. For exam-
ple, the command in level 0 can be used in from level 0 to level 14.
The commands should be input same as the displayed commands by show list. There-
fore, it is not possible to input the commands in the bracket separately.
SWITCH# show list
clear arp
clear arp IFNAME
clear ip arp inspection statistics (vlan VLAN_NAME|)
clear ip bgp * in
clear ip bgp * in prefix-filter
clear ip bgp * ipv4 (unicast|multicast) in
clear ip bgp * ipv4 (unicast|multicast) in prefix-filter
clear ip bgp * ipv4 (unicast|multicast) out
clear ip bgp * ipv4 (unicast|multicast) soft
clear ip bgp * ipv4 (unicast|multicast) soft in
clear ip bgp * ipv4 (unicast|multicast) soft out
clear ip bgp * out
clear ip bgp * soft
clear ip bgp * soft in
(Omitted)
It is not possible to input clear ip bgp * ipv4 unicast in. You should input like clear ip
bgp * ipv4 {unicast | multicast} in. The commands starting with the same character are
applied by inputting only the starting commands. For example, if you input show, all the
commands starting with show are applied.
To delete a configured security level, use the following command.
Command
Mode
Description
no privilege
Global
Deletes all configured security
levels.
no privilege view level <0-15> {COMMAND | all}
Delete a configured security
level on each mode.
no privilege enable level <0-15> {COMMAND | all}
no privilege configure level <0-15> {COMMAND | all}
no privilege dhcp-option-format level <0-15> {COMMAND |
all}
no privilege dhcp6-option-format level <0-15> {COMMAND
| all}
no privilege dhcp6-pool level <0-15> {COMMAND | all}
no privilege interface level <0-15> {COMMAND | all}
no privilege flow level <0-15> {COMMAND | all}
no privilege vrrp level <0-15> {COMMAND | all}
no privilege policer level <0-15> {COMMAND | all}
no privilege policy level <0-15> {COMMAND | all}
no privilege rip level <0-15> {COMMAND | all}
no privilege bgp level <0-15> {COMMAND | all}