Dasan V8102 - Page 8

UMN:CLI User Manual
V8102
8
Chapter/Section
Reason for Update
3.1.2 Privileged EXEC Enable Mode
‘quote COMMAND’ command added.
3.2.2 Calling Command History
‘show cli history list' command added.
4.1.3.4 Creating System Account
‘user rename NAME_FROM NAME_TO'
command added
4.1.9 Telnet Access
Telnet access related CLI added.
4.2.1 Displaying System Configura-
tion
CLI about running configuration of the system
updated.
4.2.2 Comparing Configuration
Changes
‘show compare-config' comand added.
5.2.5 Displaying IUs Information
IUs information related CLI added
5.4.5 Displaying Interface
‘show ipv6 policy' command added.
0 IPv6 PBR Configuration
Configuring a route map for IPv6 PBR on an
interface related CLI added.
5.6.4 Static Route and Default Gate-
way
Static Route related CLI added.
6.1.6.1 CPU Load
threshold of CPU load related CLI added.
6.1.9 SD Card
SD card information related CLI added.
6.1.10 Power Alarm Configuration
Alarm notification related CLI added.
6.1.11 Enabling FTP/TFTP Connec-
tion
FTP/TFTP connection related CLI added.
6.1.12 EQM Debugging
EQM debugging configuration added.
6.2.8 System Memory Information
System memory information related CLI up-
dated. Configuring a debuggin for memory
trace related CLI added.
6.2.9.1 Slowpath Filtering
‘show running-config slowpath-filter' command
added.
6.2.18 Network Service Module
(NSM) Informtaion
‘show nsm client' command added
6.2.19 Network Service Module
(NSM) Daemon Debugging
NSM daemon debugging related CLI added.
7.1.1 SNMP Service
Enabling SNMP service related CLI added.
7.1.2 Restarting SNMP Deamon
‘restart snmpd' command added.
7.1.12 Displaying SNMP Configura-
tion
Displaying SNMP OID related CLI added.
7.4.1 Syslog Output Level
Syslog output about SD card related CLI add-