Dasan V8102 - Page 809

User Manual UMN:CLI
V8102
809
13.3.3.3 Rate Limit
To configure the rate limit for downstream traffic of an ONU, use the following command.
Command
Mode
Description
uni eth UNI-PORT rate-limit
downstream PIR_BANDWIDTH
[SIR_BANDWIDTH]
ONU-Profile
Sets the downstream traffic bandwidth for UNI port.
SIR_BANDWIDTH: 0 to 2147483584 (in steps of
64Kbps)
PIR_BANDWIDTH: 0 to 2147483584
no uni eth UNI-PORT rate-limit
Deletes the configured rate limit
To configure the rate limit for downstream traffic of ONU profile, use the following com-
mand.
Command
Mode
Description
rate-limit downstream {RATE |
unlimited}
ONU-Profile
Sets the downstream traffic bandwidth for ONU.
RATE: 0 to 2147483584 (in steps of 64Kbps)
no rate-limit downstream
Deletes the configured rate limit.
To limit the maximum rate of upstream IGMP traffic, use the following command.
Command
Mode
Description
igmp us-rate-limit <1-65535>
ONU-Profile
Limits the maximum rate of upstream IGMP traffic.
1-65535: maximum IGMP packets per second
no igmp us-rate-limit
Deletes the configured IGMP packet limit.
13.3.3.4 IGMP Group List
You can configure the maximum number of multicast groups that a host on a port can join.
To specify the maximum number of IGMP groups per UNI-side port, use the following
command.
Command
Mode
Description
uni eth UNI-PORT igmp max-
groups <0-255>
ONU-Profile
Specifies the maximum number of IGMP groups for a
port.
UNI-PORT: UNI port number
0-255: number of IGMP groups (default: 16)
You can configure the maximum number of multicast groups that a host on a port can join.
To specify the maximum number of IGMP groups, use the following command.
Command
Mode
Description
igmp max-groups <0-255>
ONU-Profile
Specifies the maximum number of IGMP groups.
0-255: maximum number of IGMP groups (default: 16)
no igmp max-groups
Deletes a specified maximum number of IGMP groups.