UMN:CLI User Manual
V8102
810
13.3.3.5 Activating Administration for Ethernet UNI
To enable/disable the administration of the Ethernet UNI port, use the following command.
uni eth UNI-PORT port-admin
{enable | disable}
Enables/disables the administration of Ethernet UNI
port on the specified ONU.
To see the admin status of the ONU (ONT) UNI, use show onu uni-status command.
(See 13.2.22 Displaying ONU Information)
13.3.3.6 Mapping between T-CONT ID and DBA profile
To specify the GEM ports (priority queue) per T-CONT and the bandwidth of GEM port by
mapping between T-CONT ID and DBA profile, use the following command.
tcont TCONT-ID dba-profile DBA-
PROFILE
Specifies the priority queues of T-CONT by mapping
between the DBA profile and T-CONT ID. Sets T-
CONT’s bandwidth by specifying the DBA profile
DBA-PROFILE: DBA profile name
no tcont TCONT-ID dba-profile
Disables the mapping between T-CONT ID and DBA
profile.
13.3.4 Saving Profile
After configuring an ONU profile, you need to save the profile with the following command.
Saves an ONU profile configuration.
Even if you modify a running profile, you also need to use the apply command to apply
the changes to ONUs (ONTs).
13.3.5 Applying ONU Profile
To apply/release an ONU profile to/from connected ONUs (ONTs), use the following
command.
Applies an ONU profile to specified ONUs.
ONU-IDs: ONU ID (1 to 128) or ONU serial number
NAME: ONU profile name
Releases an ONU profile from connected ONUs.
ONU-ID: ONU ID (1 to 128) or ONU serial number
To Next Page