Dasan V8102 - Page 811

User Manual UMN:CLI
V8102
811
13.3.6 Checking ONU Profile Configuration
To display the status of ONU profile configuration, use the following command.
Command
Mode
Description
show onu status [gpon OLT-ID]
Enable
Global
Shows the status of ONU profile configuration.
show onu status [ONU-ID]
Interface
[GPON]
You should check the status of ONU profile configuration by using the show onu status
command. If the configuration is normal, the system shows “success”. Otherwise, if the
configuration fails, it shows the reason of failure.
13.3.7 Displaying ONU profile
To display a configured ONU profile, use the following command.
Command
Mode
Description
show onu-profile [NAME]
Enable
Global
Interface
[GPON]
Shows a configured ONU profile.
NAME: ONU profile name
To display the list of ONUs (ONTs) where an ONU profile is applied, use the following
command.
Command
Mode
Description
show onu-profile onu-list NAME
Enable
Global
Shows the list of ONUs (ONTs) where an ONU profile
is applied.
NAME: ONU profile name
To display the information of current profile, use the following command.
Command
Mode
Description
show current-profile
Current-
Profile
Shows the information currently configured for the
profile.
!