UMN:CLI User Manual
V8102
814
If a mapper is associated with ports of a bridge, the 802.1ag entities should be associated
with the bridge and its port, rather than with the mapper.
To configure the rate limit for an GEM port ID, use the following command.
gemport GEM-PORT-RANGE
rate-limit { upstream | down-
stream} PIR_VALUE
[SIR_VALUE]
Sets the downstream/upstream traffic bandwidth for
GEM port ID.
RANGE: GEM port range
SIR_VALUE: SIR bandwidth range of 0 to 2147483584
(in steps of 64Kbps)
PIR_VALUE: PIR bandwidth range of 0 to 2147483584
no gemport GEM-PORT-RANGE
rate-limit { upstream | down-
stream }
Deletes the configured rate limit of GEM port ID.
You should configure GEM port count for mapper before setting the rate limit for GEM
port.
To apply the configured Rate-limit profile for GEM ports, use the following command.
gemport RANGE rate-limit pro-
file NAME
Applies the configured Rate-limit profile to specified
GEM port.
NAME: Rate-limit profile name
no gemport RANGE rate-limit
profile
Removes the Rate-limit profile from the GEM port.
For the details of how to create and configure the Rate-limit profile, see 13.12 Rate-limit
Profile.
13.4.3 MAC Bridge Service Profile
A MAC bridge service profile can be configured per each UNI-side port or it can be con-
figured for the multiple UNI-side ports.
The MAC bridge service profile is comprised of ANI-side port for the upstream traffic
management and UNI-side port for the downstream traffic management. The system cre-
ates both ANI-side and UNI-side MAC bridge port config data ME.
To create a bridge ID and open a MAC Bridge Service Profile Configuration mode, use
the following command.
To Next Page