Dasan V8102 - Page 815

User Manual UMN:CLI
V8102
815
bridge BRIDGE_ID
Traffic-
Profile
Creates a bridge ID in traffic profile.
BRIDGE_ID: 1 to 32, MAC Bridge ID
After opening MAC Bridge Service Profile Configuration mode, the prompt changes from
SWITCH(config)# to SWITCH(config-traffic-pf[NAME]-bridge[BRIDGE_ID])#.
To remove the configured bridge ID from a traffic profile, use the following command.
Command
Mode
Description
no bridge BRIDGE_ID
Traffic-
Profile
Removes the configured bridge ID from a traffic profile
13.4.3.1 Max Host
To configure the max host for a MAC bridge service profile, use the following command.
Command
Mode
Description
max-hosts <0-255>
Traffic-
Bridge
Traffic
Bridge-UNI
Sets the maximum number of hosts.
0-255: maximum MAC number (0: unlimited)
no max-hosts
Deletes the configured max host.
13.4.3.2 MAC Learning
To enable/disable the ONU’s MAC learning, use the following command.
Command
Mode
Description
mac-learning {enable | disable}
Traffic-
Bridge
Enables/disables the MAC learning for this bridge ser-
vice profile. (default: enable)
13.4.3.3 UNI Port Bridge
To enable/disable the bridging feature between UNI ports, use the following command.
Command
Mode
Description
port-bridge enable
Traffic-
Bridge
Enables the UNI port bridging feature.
port-bridge disable
Disables the UNI port bridging feature.
13.4.3.4 Multicast Interworking Termination Point
The multicast GEM port is represented by a GEM network Connection Termination Point
Managed Entity (CTP ME) and a multicast GEM interworking TP ME. The multicast GEM
interworking TP is then connected into the ONU through a MAC Bridge Config Data ME.
To enable/disable the MAC bridge port configuration of MAC bridge service profile for
multicast Interworking Termination Point (IW TP), use the following command.
Command
Mode
Description