Dasan V8102 - Page 834

UMN:CLI User Manual
V8102
834
no tdm-service SERVICE_ID
Deletes the created TDM service ID.
After creating a TDM service ID with pw-ip option, the prompt changes from
SWITCH(config-traffic-pf[NAME]-ces[PORT])# to SWITCH(config-traffic-pf[NAME]-
ces[PORT]-svc[ID]-pw-ip)#. In this mode, you can perform the following configuration.
Applying TDM Pseudowire Profile
In order to configure the TDM service, you need to connect TDM pseudowire profile.
To connect TDM pseudowire profile to the current TDM service, use the following com-
mand.
Command
Mode
Description
tdm-pw-profile NAME
Traffic
CES-PW-IP
Connects TDM pseudowire profile.
NAME: TDM pseudowire profile name
no tdm-pw-profile
Disconnects the specified TDM pseudowire profile.
For the details of how to create and configure the TDM pseudowire profile, see 13.8 TDM
Pseudowire Profile.
Far-End URI
To specify the URI of the far-end, use the following command.
Command
Mode
Description
far-end-ip URI
Traffic
CES-PW-IP
Specifies the URI of the far-end, when the pseudowire
service is transported via IP.
URI: far-end URI (Both target address and port number
should be specified.)
no far-end-ip
Deletes the specified far-end URI.
UDP/TOS Configuration
To perform the configuration for protocol type-based service that is offered from an IP
host, use the following command.
Command
Mode
Description
udp port PORT tos TOS
Traffic
CES-PW-IP
Specifies the port number that offers the
UDP/TCP/TLSP/protocol type service and the value of
the TOS field of the IPv4 header.
PORT: port number
TOS: type of service per IETF RFC 1349 or a differen-
tiated services code point (DSCP) defined by IANA
(default: 0)
protocol { udp | tcp | tlsp | TYPE}
port PORT tos TOS
i