Chapter 4 -Operational Procedures-
102
AS-410M Auto Slide Preparation System
Item to be checked Descriptions
Slide type
(System with SS, BR)
The THERMAL OUT button is for setting the thermal printing output time
for the 4 registered types of slide glasses.
Drip Water
Check the application medium (drip water) bottle for proper liquid level.
If there are bubbles in the piping, press the FLUSHING button and remove
the bubbles.
Humidifying water Check the humidifying water bottle for proper liquid level.
Remaining Blades The number of remaining blades appears here. When no dedicated-
replacement blade is set in place, the counter defaults to “0.” The number
of remaining blades can be set manually.
Change Blade (Knife)
Cassette
Touch CHANGE at BLADE. The “Change Blade Cassette” prompt will
appear, then turn OFF the power before replacing the dedicated-
replacement blade cassette. Touch CANCEL to cancel the replacement.
Tape remaining
This indicator shows how many section slides can be prepared using the
remaining length of tape.
Change tape
Touch CHANGE under Tape, and the “change carrier tape” prompt will
appear. Then turn OFF the power before replacing the tape.
Touch CANCEL to cancel the replacement.
Change blade cassette prompt
Change carrier tape prompt
SLIDE GLASS SELECTION screen
Thermal printing output time setting screen
To Next Page
Loading...
Need help?
General