To Next Page

To Previous Page

Chapter 3 - Preoperational Setup -

AS-410M Auto Slide Preparation System

⑥ Set each guide disk back in place. Turn the carrier tape feeder and the carrier tape take-up reel

clockwise in place securely.

⑦ Confirm no bent or twist on Carrier

Tape and no derailment from the

roller, then press OK.

⑧ Confirm enough tape is

remaining.

For Carrier tape replacement, the system measures the tape remaining at initializing,

therefore it can be performed when the power is off.

！ Note

Questions and Answers:

Need help?

Do you have a question about the DNS AS-410M and is the answer not in the manual?

DNS AS-410M Specifications

General