214 Scanning
Setting up a client computer
To allow networking, each client computer in the network
requires a Network Interface Card and a Network Interface Card
(NIC) driver. Install the Network Interface Card and Network
Interface Card (NIC) driver on each client computer. For details
on the installation procedures, refer to the corresponding
manuals included with the card.
Installing the TCP/IP protocol
To install the TCP/IP protocol on a client computer on the
network, follow the instructions below.
For Windows XP and 2000 users
Note for Windows XP users:
Screen shots for Windows 2000 are used in this section, so they may
differ in appearance from what actually appears on your screen. The
instructions are the same, except as noted.
1. For Windows XP users:
Click Start, right-click My Network Places, and then select
Properties.
To Next Page
Loading...
Need help?
General
