Epson AcuLaser CX11 - Removing a Memory Module

Installing Options 335
10
10
10
10
10
10
10
10
10
10
10
10
7. To confirm that the option is installed correctly, print a status
sheet. See “Printing a Status Sheet” on page 393.
Note for Macintosh users:
When you have attached or removed product options, you need to
delete the product using Print Setup Utility (for Mac OS X 10.3)
or Print Center (for Mac OS X 10.2 or below), and then re-register
the product.
Removing a memory module
c
Caution:
Before you remove a memory module, be sure to discharge any
static electricity by touching a grounded piece of metal.
Otherwise, you may damage static-sensitive components.
w
Warning:
Be careful when working inside the product as some components
are sharp and may cause injury.
Perform the installation procedure in reverse.
When removing a memory module from its slot, press the clip
and pull out the memory module as shown below.