Epson AcuLaser CX11 User Manual

Using the Control Panel 299
9
9
9
9
9
9
9
9
9
9
9
9
USB Menu
These settings control communication between the product and
the computer when using a USB interface.
*1
After this item is changed, the setting value takes effect after a warm boot
or after the power is turned on again. While it is reflected in the Status Sheet,
the actual change takes effect after a warm boot or after the power is
turned on again.
*2
Displayed only when a USB external device is connected and the USB Ext
I/F Confg is set to Yes. The contents of the settings depend on the USB external
device settings.
*3
Displayed only when the Get IPAddress is set to Auto. This setting cannot be
changed.
*4
When the Get IPAddress is changed from Panel or PING to Auto, the panel
setting values are saved. When Auto is changed to Panel or PING, the saved
setting values are displayed. 192.168.192.168 if the settings are not made
from the panel.
Item Settings
USB I/F
*1
Yes, No
USB Speed
*1
HS, FS
USB ExtI/FConfg
*1
Yes, No
Get IPAddress
*2
Panel, Auto, PING
IP (IP address)
*2*3*4
0.0.0.0 to 255.255.255.255
SM (Subnet mask)
*2
0.0.0.0 to 255.255.255.255
GW (Gateway address)
*2
0.0.0.0 to 255.255.255.255
Netware
*2
On, Off
AppleTalk
*2
On, Off
MS Network
*2
On, Off
Rendezvous
*2
On, Off
USB EXT I/F Init
*2
-

Epson AcuLaser CX11 Specifications

General

Brand	Epson
Model	AcuLaser CX11
Category	All in One Printer
Language	English